How to design front panels of pants?
Start drawing from the first film. The hip line takes 1/3 of the rise, as the margin of the circumference, add 2cm-3cm to H/4. On the rung line, measure the hips in 4 equal parts and extend the thickness to the left by 1/4 (the width of the front door). Take the crotch length down from the midpoint of the pant line and draw the foot line. The inseam of the knee line is 5cm upwards. The width of the leg opening is 11cm on both sides of the pant line symmetrically.
Under normal circumstances, after entering 0.5cm—0.7cm inward on the waistline of the front center, the rise arc is connected. However, in the case of a special body, because of the calculation of the amount of obesity, the front rise line will also deviate from the front The center is raised again. Take the waist line W/4+3cm~4cm, draw the arc-shaped side seam over the hip line, extend the side seam up by 0.5cm, and draw the waist line again. The live pleats on the waist are sewn 3cm-4cm from the pant line to the side, and a line is drawn to the intersection of the knee line and the pant line. The side seam of the lower part is to first connect the foot opening and the horizontal crotch line, and then draw an arc on the knee line 1cm inward. Take the same width of the knee line on the side seam to the front side and draw the crotch line.
